REDWAY BATTERY / KNOWLEDGE
How Long Does a 24V Lithium Battery Take to Charge?

A 24V lithium battery’s charge time depends mainly on capacity, starting state of charge and approved charger current. A first estimate is hours = Ah to replace ÷ charger amps, then add allowance for conversion losses and the constant-voltage finishing stage. The charger voltage and current must remain within the exact battery and BMS specification.
Last updated:
24V lithium battery charging-time formula
Ah to replace = rated Ah × change in state of charge. Base time = Ah to replace ÷ charger amps.
Example: a 100Ah battery charged from 20% to 100% needs approximately 80Ah replaced. With a 20A charger, the base time is 80 ÷ 20 = 4 hours. Allowing roughly 10–20% for taper and losses gives a planning range of about 4.4–4.8 hours. Use measured charger output and the manufacturer’s profile for a more precise estimate.
| Battery and starting point | Charger | Base calculation |
|---|---|---|
| 24V 50Ah, 20% to full | 10A | 40Ah ÷ 10A = 4h plus taper |
| 24V 100Ah, 20% to full | 20A | 80Ah ÷ 20A = 4h plus taper |
| 24V 200Ah, 50% to full | 40A | 100Ah ÷ 40A = 2.5h plus taper |
Why the final part charges more slowly
During constant-current charging, the charger supplies its set current until pack voltage approaches the target. It then holds voltage while current tapers. Cell balancing, temperature controls and BMS limits can extend this stage.
Manufacturer specifications publish model-specific charge voltage and maximum charge current; Victron, for example, lists these separately in its Lithium Smart technical data. Do not copy those values to an unrelated pack.
Checks before choosing a faster charger
- Battery maximum and recommended charge current.
- Charger voltage profile for the exact chemistry and series count.
- BMS charge-current and temperature limits.
- Cable, connector and fuse ratings.
- Whether parallel batteries require matched connections.
For related charging and capacity guidance, visit the LiFePO4 sizing and capacity hub.
FAQ
How long does a 24V 100Ah lithium battery take to charge?
From 20% to full, a 20A charger has a four-hour base calculation; taper and losses commonly make the actual time longer.
Can I double charger current to halve charging time?
Only if the battery, BMS, wiring and connector approve the higher current. The finishing stage also prevents perfectly linear time reduction.
Why does charging stop in cold weather?
The BMS may block charging below its permitted cell temperature to protect the battery.

